Self Contained
Marine Air Conditioning Installation Instructions |
| Choose a
location that is dry and accessible for service. The air
access should be from the return air source only--and it
should not be contaminated by air from the engine room,
bilge, heads, holding tanks, etc. Placement of the unit
should be adjacent to a low return air access from the area
to be conditioned. Never install a unit in an engine room.
(Split systems are available for compressor/condenser installation
in the engine room.)
This self contained
unit is furnished with a complete installation kit as
shown below. Secure the unit on a horizontal surface sufficient
for the weight of the unit and the rocking motion of the
boat. Condensation drains must be routed downward without
any kinks or restrictions to a sump or overboard discharge,
and should be securely fastened as should all components
of the system. All equipment should be properly grounded.
Digital control is
standard. However, analog control is also
available. |
|
| |
|
Conplete Installaion Kits Include: |
| 1 |
Air conditioner base |
| 2 |
Air conditioner control
panel |
| 3 |
Black, white &
green wires for shore power or generator |
| 4 |
Red, white, yellow,
green & brown wires for electrical box |
| 5 |
Control probe to be attached to
evaporator fin |
| 6 |
Electrical box |
| 7 |
Water condenser "in" from sea water
pump discharge |
| 8 |
Water discharge "out" from condenser
back to sea |
| 9 |
Two (2) ½" hose clamps (water
in) |
| 10 |
Two (2) 5/8" hose clamps (water
out) |
| 11 |
5/8" hose to sea water pump discharge |
| 12 |
5/8" hose to thru-hull discharge
fitting |
| 13 |
Two (2) 5/8" hose clamps for water
discharge |
| 14 |
5/8" plastic thru-hull discharge
fitting |
| 15 |
Two (2) 1/2" hose clamps for water
discharge pump |
| |
|
|
 |
| 16 |
90" elbow from pump discharge |
| 17 |
Sea water pump |
| 18 |
Black, white &
green wire harness for control panel from pump |
| 19 |
Purple, white &
green for control to be connected to pump (black wire connects
to purple wire) |
| 20 |
3/4" sea water strainer |
| 21 |
2/4" threaded to 3/4" barb fitting |
| 22 |
Two (2) 3/4" hose clamps |
| 23 |
Two (2) 3/4" hose clamps |
| 24 |
3/4" hose |
| 25 |
3/4" threaded to 3/4" barb fitting |
| 26 |
Ball valve |
| 27 |
Bronze sea-cock |
| 28 |
Air discharge plenum |
| 29 |
4" non-insulated duct - 25 ft. |
| 30 |
4" round grill for air discharge |
| 31 |
Aluminum return air grill |
| 32 |
Optional supply grills |
| 33 |
Optional grill box |
| |
|
|
| |
For
Units 12,000 and 16,000 BTU 3 supply duct kits are provided.
For units above 16,500 BTU
4 supply kits are provided.
No additional parts required.
For systems over 16,000 BTU, Kit is optional. |
|
